) |
) |
) |
||
| 01 | 02 | 03 | ||
|
1. Cut the foil connection between transistor B1204 “C” Plate and Point A. 2. Solder A and B points together.
|
||||
|
If you use high performance (high torque & high speed) servos on an old AM 2 channel receiver, the BEC will cause problems because the BEC can not supply enough current to push the servos which draw more current due to high performance. For Futaba：FP-R112JE,FP-R 122JE
|
|
|
|
|
||
| 01 | 02 | 03 | ||
|
1. Cut the foil connection between transistor B1204 “C” Plate and Point A. 2. Solder A and B points together.
|
||||
|
© GWS Grand Wing Servo-Tech Co., Ltd., All Rights Reserved. |